I realize everyone is very busy around this time, but we’re in the final steps of getting the reprap working, so we really need lots of help to push through with getting it printing!
Where: ILC Woodshop
When: 7:00 pm, 5/4/11
I realize everyone is very busy around this time, but we’re in the final steps of getting the reprap working, so we really need lots of help to push through with getting it printing!
Where: ILC Woodshop
When: 7:00 pm, 5/4/11
We’re having a meeting tonight with prospects of extrusion!
Where: ILC Woodshop
When: 7:00 pm, 29/3/11
Since weekdays are not working for some people, we’re going to try out a Saturday meeting. Hopefully 4:00pm is a good time for people?
You know the routine… ILC woodshop, 4:00 pm, 26/3/11… yada yada yada.
Did I mention that the RepRap moves? Yeh, It moves! In not one, not two, but three directions! We just need to figure out a way to mount the extruder now. Exciting.
We’re having a meeting tonight, starting earlier than usual at 6.
Where: ILC Woodshop
When: 6:00 pm, 24/3/11
As usual, any other projects welcome too.
Hi Folks,
We’re having a meeting tonight, with high hopes for getting the RepRap moving around, plotting, and maybe even printing!
Where: ILC Woodshop
When: 7:00 pm, 22/3/11
As usual, any other projects welcome too.
Meeting Tonight!
Where: ILC Woodshop
When: 7:00 pm, 15/3/11
Hey folks,
Where: ILC Woodshop
When: 7:00 pm, 8/3/11
What: Replace Z pulleys, test motion of all axis, connect opto endstops, assemble extruder, [stuff we’ve forgotten], print shot glasses!
As usual, any other projects welcome too.
It seems that most people can’t make it to tonight’s meeting, however if you would like to attend, you can borrow the keys. We have replacement pulley’s for the Z-axis printed, that are ready to be swapped in.
To get the keys, txt 613 770 1061 or send an email to kingstonmodlab@gmail.com
The RepRap is almost complete, missing only the extruder. Extruder parts are now printed, which need assembling. We will be meeting up this week on Tuesday and Thursday.
Where: ILC Woodshop
When: 7:00 pm, 10/2/11
What: Assemble extruder, mount extruder controller board, figure out software for extruder, mark bolt for hobbing. Any other projects welcome too!
Reminder- Meeting Today!
Where: ILC Woodshop
When: 7:00 pm, 10/2/11
What: Attach Y-axis, Hook up electronics. Plot with a pen? Figure out Wade Extruder. Any other projects welcome too!